| Author | Post |
|---|
Ron458
Member
| Joined: | Wed Dec 5th, 2007 |
| Location: | |
| Posts: | 26 |
| Status: |
Offline
|
| Mana: |    |
|
Posted: Fri Feb 22nd, 2008 05:21 pm |
|
| Don, could you give me a pointer or two on removing the 3jaw chuck? I know it screws on & it apears that I have some holes in the sleve behind the chuck but I cant get it to move. Thanks, Ron
|
Dongizmo
Super Moderator
| Joined: | Tue Dec 19th, 2006 |
| Location: | Warren, MI, USA |
| Posts: | 182 |
| Status: |
Offline
|
| Mana: | |
|
Posted: Fri Feb 22nd, 2008 05:54 pm |
|
Ron.
Remove the 2 clamps, use either a rod (the chuck wrench handle fits) or a hook spanner to hold the spindle, then use a bar in the chuck jaws to unscrew the chuck.
Don
Attachment: HPIM2376.JPG (Downloaded 22 times)
|
Ron458
Member
| Joined: | Wed Dec 5th, 2007 |
| Location: | |
| Posts: | 26 |
| Status: |
Offline
|
| Mana: | |
|
Posted: Fri Feb 22nd, 2008 07:30 pm |
|
| Thats what I was doing but it was bending the little bar. Its OK. I warmed it up a little & (expand the thread area some) & aded oil. She finally poped off. Thanks Don.
|
Ron458
Member
| Joined: | Wed Dec 5th, 2007 |
| Location: | |
| Posts: | 26 |
| Status: |
Offline
|
| Mana: | |
|
Posted: Fri Feb 22nd, 2008 07:34 pm |
|
| Hey, the pic looks just like the one I got. Have you figured anything out with the threads? I cut 1 in 16" threads last night using the 1in 18" threads setting & they worked! just a little bind at the end but not enough to hurt the threads! Thanks, Ron
|
Dongizmo
Super Moderator
| Joined: | Tue Dec 19th, 2006 |
| Location: | Warren, MI, USA |
| Posts: | 182 |
| Status: |
Offline
|
| Mana: | |
|
Posted: Fri Feb 22nd, 2008 07:41 pm |
|
We are working on the threading right now, I think we are going to have the manufacturer look into it, I am thinking the chart is off.
Don
|
Ron458
Member
| Joined: | Wed Dec 5th, 2007 |
| Location: | |
| Posts: | 26 |
| Status: |
Offline
|
| Mana: | |
|
Posted: Fri Feb 22nd, 2008 07:46 pm |
|
| No problem. As long as you have the same problems I have I know we can find a solution! Thanks again, Ron
|
Current time is 08:37 am | |
|
